Spam Filter ISP Support Forum

  New Posts New Posts RSS Feed - RCPT TO
  FAQ FAQ  Forum Search   Register Register  Login Login

RCPT TO

 Post Reply Post Reply
Author
Stephane_999 View Drop Down
Newbie
Newbie
Avatar

Joined: 18 September 2007
Location: Canada
Status: Offline
Points: 1
Post Options Post Options   Thanks (0) Thanks(0)   Quote Stephane_999 Quote  Post ReplyReply Direct Link To This Post Topic: RCPT TO
    Posted: 18 September 2007 at 1:48pm
Hi, We seem to experience a problem with large authorized lists (950 names)
 
When i look in the Connections window, i see many connections some go through very fast but a lot of them get stuck with a status 'RCPT TO'.  I used the debug view window to monitor *.*.*.*, and i see that spamfilter does not send back the <<250 Address okay prompt rigth away.. or even never..
 
We had this problem with 3.5.4.704 registered, upgraded to 3.5.4.713 and still experiencing the problem, i also tried to change the timeout in the spamfilter.ini, but no change.
 
Any idea ?
Back to Top
LogSat View Drop Down
Admin Group
Admin Group
Avatar

Joined: 25 January 2005
Location: United States
Status: Offline
Points: 4065
Post Options Post Options   Thanks (0) Thanks(0)   Quote LogSat Quote  Post ReplyReply Direct Link To This Post Posted: 18 September 2007 at 3:17pm
Stephane_999,

Using the debug view with *.*.*.* will not provide reliable results, as you will be monitoring *all* traffic to SpamFilter, and the debug data may be overwhelming to SpamFilter. The debug view is intended to be used with a single IP/network to pinpoint problems with that specific network.

In regards to the connections appearing "stuck", are they always from the same IPs? If so, you can use the debug view to just capture data from those IPs, and we can try to see what the problem is. If there is no pattern to them, do the "from" email addresses reported there "appear" to be legitimate addresses, or do they look like spammers? Please note that often spammers will probe mail servers, and it is somewhat normal to see a few pending connections.

This said, SpamFilter will perform many of its tests after receiving the "RCPT TO" command, and prior to outputing a "250" code if the recipient is valid. A delay in this process cold occur if the DNS server(s) used by SpamFilter is slow in responding to DNS lookups (SpamFilter has a 5 second defualt timeout on DNS queries). Could you check to ensure the DNS server(s) is working properly and responding to queries in a timely manner?
Roberto Franceschetti

LogSat Software

Spam Filter ISP
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.047 seconds.